SCREEN  The FPGA data for ADC1 update procedure. May.17,2002
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Before you output the data to PIF Engine through ADC1,
you'll need to update it's FPGA data for fix the some problem.


* How to update the FPGA data
1. Start Explorer and open 'RomUpper' directory in this floppy.
   And launch "RomUpper.exe" in this directory.
2. This application has ask the expanding directory.
   Please input target directory (Ex. "C:\temp") on local HardDisk.
3. Open the directory (C:\temp) at explorer.
   And launch "ADCRomUpper.exe" in this directory.
4. Chose target card in the 'Choose target Card' dialog.
   (If you use only one card, you do not need to change the default.)
   And push the [OK] button.
5. After a moment, show the current version and update version of FPGA
   data in a dialog.
   Check the update version is newer than current, and push the [OK] button.
   (If each version are same, you do not need to update FPGA.)
6. Execute updating. An end of update requires re-starting of a system.
   A floppy disk is extracted, shutdown the system and the power of Platform
   is turned off. After then switch on a power and start a system.

Cautions: The data of FPGA is not updated only by re-starting, without
          turning off the power of Platform.

After update is completed, the extract files on the hard disk (C:\temp)
is unnecessary. You may delete these files.

* How to check the result of update
1. Start Explorer and open 'TestTools' directory in this floppy.
   And launch "ADC_information.exe" in this directory.
2. If the version of each FPGA is the same version of data displayed at
   the time of update(Step.5), the update was completely.

.eof